Use and Care Manual

ASSEMBLY EB600RT

18 X7505200806

Note: Hang handle freely from

blower to assure throttle

cable is not twisted before

installing handle (E).

5. Position cable along the outside

of elbow. Loosen knob (H) on

handle (E). Align notches in

handle with tabs (F) and install

onto swivel pipe (C) past long ridges in pipe.

6. Insert anti-static wire through swivel pipe.

7. Assemble swivel pipe into flexible pipe and tighten clamp (A).

8. Clip throttle cable into throttle cable guide loop.

9. Move handle (E) to desired

position. Tighten knob (H) hand

tight.

10. Assemble straight pipe (K) onto

swivel pipe, until you feel light

resistance. Hold swivel pipe

and turn straight pipe

clockwise, engaging positive

locking channels, until

connection is firm. Do not force

connection.

11. Assemble straight pipe with

decal (J) to straight pipe as in

step 10.

Note: Blower use will eventually

loosen pipe connections.

Exclusive positive locking

system allows pipes to be

tightened. If loosening occurs, remove two straight pipes and

install according to instructions 10 & 11.