Use and Care Manual

EB600RT OPERATION

X7505200806 23

Starting Cold Engine

• Recoil starter: Use short pulls - only 1/2- 2/3 of rope length for starting.

Do not allow the rope to snap back in. Always hold the unit firmly.

1. Throttle Lever

Move throttle lever (A) to IDLE

position.

2. Choke

Move choke (B) UP to COLD

START ( ) position.

3. Purge Bulb

Pump purge bulb (C) until fuel is

visible. Pump bulb an additional

4 or 5 times.

4. Recoil Starter

Pull recoil starter handle (D) until engine fires, or a maximum of 5 pulls

5. Choke

After engine fires (or 5 pulls),

move choke lever back to RUN

( ) position, then pull starter

handle/rope until engine starts

and runs. Allow unit to warm up

at idle for several minutes.

Note: If engine does not start

with choke in “RUN”

position after 5 pulls,

move choke to COLD

START ( ) position, and

repeat steps 3- 5.

6. Throttle Lever

Allow engine to warm up for several minutes before use.

7. Throttle Lever

After engine warm-up, squeeze throttle trigger, then move throttle lever to

set desired operating speed.