Use and Care Manual

OPERATION EB600RT
26 X7505200806
© 11/19 ECHO Incorporated
3. Allow the engine to warm up at
a fast idle for a few minutes.
4. Control engine speed with
throttle trigger (B), or for
continuous use, set engine
speed with throttle lever (A).
5. Use lower speed to blow dry
leaves from walks, patios and
drives. Use rakes and brooms
to loosen debris before blowing.
6. Additional speed may be necessary to clean grass and leaves from a
lawn or flower bed.
7. Higher speed may be necessary to move gravel, dirt, snow, bottles or
cans from a driveway, street, parking lot or stadium.
8. Always stop unit using stop engine procedure.
Note: Never use a higher speed setting than necessary to perform a
task. Remember, the higher the engine speed, the louder the
blower noise.
9. Minimize dust by using blower at lower speeds or dampen surface with
water. Blower can be used to clean most surfaces when water
conservation is desired.
10. Use the full blower pipe configuration when blowing.
11. After using blowers and other equipment, CLEAN UP! Dispose of
debris in trash receptacles.
Contacting blower pipe tip on abrasive surfaces can create
sharp cutting edges and can result in personal injury if touched.
Do not scrape or drag blower pipe tip when operating or
transporting unit. Replace blower pipe assembly if protective
metal ring is worn, cracked or deformed.
A
B