Use and Care Manual

EB770RT OPERATION

X7531127000 23

2. Move choke (C) UP to COLD

START ( ) position.

3. Pump purge bulb (D) until fuel is

visible. Pump bulb an additional

4 or 5 times.

4. Pull recoil starter handle (E) until

engine fires, or a maximum of 5

pulls

5. After engine fires (or 5 pulls),

move choke lever back to RUN

( ) position, then pull starter

handle/rope until engine starts

and runs. Allow unit to warm up

at idle for several minutes.

Note: If engine does not start

with choke in “RUN” position after 5 pulls, move choke to

COLD START ( ) position, and repeat steps 4- 5.

6. Allow engine to warm up for several minutes before use.

7. After engine warm-up, move throttle position lever gradually to increase

engine RPM to desired operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the

choke.v

1. Move throttle position lever (A) to

IDLE position.