User's Manual

Main Menu Parameters
The Main Menu organizes the available transmitter parameters into three categories:
• Radio
• Audio
• Utilities
To change a parameter, press the enter button to enable editing and use the arrow buttons to change values or settings. When finished, press enter to
save.
Radio Menu
Group and Channel
Press the enter button to enable editing of a
group (G:) or channel (C:). Use the arrow buttons
to adjust the values.
Frequency
Press the enter button once to edit the first 3
digits, or twice to edit the second 3 digits.
RF Power
Higher power settings can extend the range of
the transmitter.
RF Output
- On: RF signal is active
- Mute: RF signal is inactive
Audio Menu
MicOffset
Adjust Mic Offset level to balance mic
levels when using two bodypacks for
frequency diversity.
Pad
Adjust the pad to avoid overloading the
audio input.
PolarityPos
Selectable polarity assignment for LEMO
connector transmitters:
- Pos: Positive pressure on microphone dia-
phragm produces positive voltage on pin 2
(with respect to pin 3 of XLR output) and the tip
of the TRS output.
- Neg: Positive pressure on microphone dia-
phragm produces negative voltage on pin 2
(with respect to pin 3 of XLR output) and the tip
of the TRS output.
MuteMode
When enabled, the power switch is
configured as a mute switch for the audio:
- Power switch on: audio signal on
- Power switch off: audio signal muted
Tone
Transmitter will generate a continuous test
tone. The tone can be set to 400 Hz or
1000 Hz.
Level
When enabled, allows for adjustment of the
output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 9 letters or
numbers.
Lock
Locks the transmitter controls and
power switch.
Drop Mark
When enabled, press the enter
button to drop a marker in Wireless
Workbench or Shure ChannelsPlus.
Versions
Displays transmitter information:
- FW: Installed firmware
- HW: Hardware version
- SN: Serial number
Batt Info
Displays battery information:
- Time: Battery runtime
- Health: Percentage of current battery
health
- Charge: Percentage of change
- Cycles: Record of the number of charging
cycles for the installed battery
- Temp: Battery temperature in Fahrenheit
and Celsius
- mAh: Remaining mAh for the installed
battery
Reset All
Restores all transmitter parameters to
factory settings.
Tips for Editing Menu Parameters
• To access the menu options from the home screen, press the enter button. Each additional press of the enter button advances to the next menu
screen.
• A menu parameter will blink when editing is enabled
• To increase, decrease or change a parameter, use the arrow buttons
• To save a menu change, press enter
• To exit a menu without saving a change, press exit
DRAFT
9.8.16