Owner's Manual

Transmitter LED Indicators
LED Indicator Status
Green
Ready
Rapldly Flashlng Red Controls locked
Solld Red
Battery power low (less than 1 hour rema ining•)
Flashlng Red and shuts off Batteri es dead (change batte ri es to power on transmitter)
•For alkaline batteries only. For rechargeable batteries, so lid red means the batteries are dead.
Single System Set Up
Before you begin, turn off all transmitters and turn on any equipment (other microphones or pe rs onal monitor ing sys t em s)
that could cause interference during the performance.
1. Press and release the group button on the receiver.
The receiver scans for the clearest group and
channel.
Note: If you want to stop the scan, push the group
button aga in.
2. Turn on transmitter and change the group and cha n-
nel to match the receiver ( See Setti ng T rans mi tte r
Gr oup and Channel).
Once the system is se t up, perform an au dio check and adj us t
the gain if necessary.
Setting Transmitter Group and Channel
Transmitter group and channel must be manually set to match the receiver.
Group (letter)
1. Press and release the group button on the transmitter
to activate the display. Press the group button again
and the display flashes.
2. While the display is flashing, press the group button
again to advance to the desired group setti ng .
Channel (number)
If channel needs to be changed, follow the same pro-
cedure using the channel button instead of the group
button.
Note:
• Wh en the group and channel correctly match the
receiver, the ready LED on rece iver illuminates.
• After manual setup, the transmitter alternately displays
the group and channel setti ng for about two seconds.
fol
~
group
r
1*~
x2
OJ
channel
7
1 ~
x2
3