MX405 MX410 MX415 Gooseneck Microphones and Accessories The Shure miniature gooseneck microphones, MX405, MX410 and MX415, user guide.
Shure Incorporated Table of Contents MX405 MX410 MX415Gooseneck Microphones and Ac cessories 3 General Description MX400SMP Pin Assignments 12 DIP Switches 12 LED Logic 13 3 MX400DP Desktop Base Features 3 Model Variations 3 Snap-Fit Windscreen 8 Interchangeable Cartridges 9 MX400SMP Surface Mount Preamp 14 Installation 15 Cable 15 MX400DP DIP Switches 16 Local Mute Control 17 Logic Mute Control (Automatic Mixing) 18 9 Accessories 10 Installation 11 Specifications 19 Cer
Shure Incorporated MX405 MX410 MX415 Gooseneck Microphones and Accessories General Description Shure MX405, MX410, and MX415 miniature gooseneck microphones are suitable for boardrooms and other sites where aes thetics are important. Permanently mount them at conference tables or lecterns using the MX400SMP surface mount, or use the MX400DP moveable desktop base, which includes a configurable mute button with logic output. Also compatible with the MX890 wireless desktop base and the ULXD8 wireless base.
Shure Incorporated 4/25
Shure Incorporated 5/25
Shure Incorporated Gooseneck Microphones 5" Cardioid Gooseneck Microphone MX405LP/C 5" Supercardioid Gooseneck Microphone MX405LP/S 5" Mini-shotgun Gooseneck Microphone MX405LP/MS 5" Gooseneck with Red Top LED (no cartridge) MX405RLP/N 10" Cardioid Gooseneck Microphone MX410LP/C 10" Supercardioid Gooseneck Microphone MX410LP/S 10" Gooseneck with Red Top LED (no cartridge) MX410RLP/N 10" Cardioid Dualflex Gooseneck Microphone MX410LPDF/C 10" Supercardioid Dualflex Gooseneck Microphone MX410
Shure Incorporated 15" Gooseneck with Red Top LED (no cartridge) MX415RLP/N 15" Cardioid Dualflex Gooseneck Microphone MX415LPDF/C 15" Supercardioid Dualflex Gooseneck Microphone MX415LPDF/S 15" Dualflex Gooseneck with Red Top LED (no cartridge) MX415RLPDF/N 15" Cardioid Dualflex Gooseneck Microphone with Red Top LED MX415RLPDF/C 15" Supercardioid Dualflex Gooseneck Microphone with Red Top LED MX415RLPDF/S 5" White Gooseneck Microphone (no cartridge) MX405WLP/N 5" White Gooseneck Microphone w
Shure Incorporated Mini-shotgun Mic Placement Snap-Fit Windscreen • Snap into the groove below the cartridge. • To remove, spread the gap with a screwdriver or thumbnail. • Provides 30 dB of "pop" protection.
Shure Incorporated Interchangeable Cartridges Microflex microphones use interchangeable cartridges that allow you to choose the polar pattern for different installations. Cartridge Polar Patterns MX400SMP Surface Mount Preamp Permanent mount for conference tables or lecterns. Includes LED logic input.
Shure Incorporated Accessories Furnished Accessories MX400SMP Surface Mount Kit 10/25
Shure Incorporated Installation Note: Over tightening the wing nut reduces shock isolation. Caution: To prevent bending pins, line up key with notch and seat connector fully before twisting to lock.
Shure Incorporated MX400SMP Pin Assignments 5-Pin XLR DIP Switches Set DIP Switch 1 up to engage the low cut filter, which attenuates frequencies by 6 dB per octave below 150 Hz.
Shure Incorporated Switch Down (default) Up 1 Full frequency response Low cut filter 2 LED steady LED flashes LED Logic To operate the LED indicator, use the included 5-pin XLR connector to wire the microphone to an automatic mixer or other logic device. Note: Connect the LED IN to the gate output to illuminate the LED when the channel is gated on. Do not use the relay ports on Crestron and AMX devices. Use the I/O logic ports instead.
Shure Incorporated MX405, 410, 415 Green Red MX405R, 410R, 415R Logic LOW (0 V) Logic HIGH (+5V) Red Off/flashing MX400DP Desktop Base The MX400DP moveable desktop base includes a configurable mute button with logic output.
Shure Incorporated Installation Caution: To prevent bending pins, line up key with notch and seat connector fully before twisting to lock. Cable The 20 ft. attached cable is terminated with a 3-pin XLR connector. For logic applications, open the XLR connector to access the three unterminated logic conductors.
Shure Incorporated MX400DP Pin Assignments 3-Pin XLR MX400DP DIP Switches Caution: Failure to reinstall the setscrew will reduce RF immunity.
Shure Incorporated Switch Down (default) Up 4 Full Frequency Range Low Cut Filter (attenuates 6 dB per octave be low 150 Hz) 5 LED Steady LED Flashes Local Mute Control The microphone ships configured for local (manual) mute control (DIP Switch 3 down). In this mode, the PUSH button on the microphone mutes the audio signal at the microphone. Audio is not sent to the audio outputs when muted.
Shure Incorporated Button Behavior SWITCH OUT Logic Signal DIP Switch Setting Toggle: Push and release to toggle the mi crophone on or off. Mic is active when powered on. Push and release sets SWITCH OUT to 0 V. Push again to toggle back to +5 V. Toggle: Push and release to toggle the mi crophone on or off.
Shure Incorporated Controlling the LED Using Logic LED IN When configured for logic mute control, connect the LED IN conductors to an external switch, relay, or a TTL gate (gate out) on an automatic mixer. The MX400DB contains an internal pull-up resistor circuit. • The LED illuminates green/red when the MX396 LED IN is grounded (orange wire connected to the green wire). • The LED illuminates red/off when LED IN is lifted (orange wire is NOT connected to the green wire).
Shure Incorporated Supercardioid 27 dB SPL Mini-shotgun 26 dB SPL Signal-to-Noise Ratio Ref. 94 dB SPL at 1 kHz Cardioid 66 dB Supercardioid 68 dB Mini-shotgun 68 dB Dynamic Range 1 kΩ load, @ 1 kHz 93 dB Common Mode Rejection 10 to 100,000 kHz 45 dB, minimum Clipping Level at 1% THD −8 dBV (0.
Shure Incorporated Cable MX400DP 6.1 m (20 ft) attached cable with shielded audio pair terminated at a 3pin male XLR and three untermi nated conductors for logic control Environmental Conditions Operating Temperature –18–57°C (0–135°F) Storage Temperature –29–74°C (–20–165°F) Relative Humidity 0–95% Power Requirements Phantom Power 48–52 V DC, 8.
Shure Incorporated 22/25
Shure Incorporated 23/25
Shure Incorporated 24/25
Shure Incorporated Certifications This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking. The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department: EMEA Approval Jakob-Dieffenbacher-Str. 12 75031 Eppingen, Germany Phone: +49-7262-92 49 0 Fax: +49-7262-92 49 11 4 Email: info@shure.
