Owner`s manual

8.2 Use of Remote Controller
The remote controller is designed for standard wiring and to fit a standard electrical box
with dimensions 86 x 86mm, fixed hole distance 60mm. The illustration below shows how
to open and fix the controller and base box. You may request from SIDDONS extension
wiring for the remote controller and a blank panel to fit onto the casing after relocating the
controller.
Complete the installation by pressing the
digital controller down firmly to reengage
the tabs.
Put the digital controller into the base box and
tighten the two setting screws.
Illustration 3
Illustration 4
Illustration 1 Illustration 2
Use a flat screwdriver to press down the two
tabs and lift open the face covering.
Remove the top covering leftwards to
disengage two top tabs.
8.1 Optional Mounting and Fixing of the Remote Controller:
17
8.2a :User Interface and Functions
Heat pump on/off
button
Operating status
ELECELEC
1
2
%%
Buttons lock icon
CLOCKCLOCK
TIMERTIMER
Defrost Mode (continuous flashing)
Water heating mode
Manual water supply flow and return mode
(flashing)
Automatic water supply flow and return
mode (on but not flashing)
Electric heater mode - N/A
Timer 1 (heat pump on/off timer setting)
Timer 2 ( water supply flow and return mode
on/off timer setting)
Manual electric heater
on/off button - N/A
Open the controller
(push tabs in)
Timer setting button
Clock setting button
Water cooing mode - N/A
Additional water pump - N/A
Heat pump fan only - N/A
AIR TO WATER HEAT PUMP WATER HEATERAIR TO WATER HEAT PUMP WATER HEATER