User Guide Cordless Digital Telephone 2060isdn

Basic settings

I_KAP03.FM5

Gigaset 2060isdn, Inland:

8.12.98

A30853-X210-B101-1-19

Setting point-to-multipoint

Point to multipoint is the default access mode of your Gi-

gaset 2060isdn. Use the procedure described here to

configure the point-to-multipoint mode and define opera-

tion as local or multicell (in other words mobile units con-

figured for use with one or more base stations).

When configured in this way your Gigaset 2060isdn is

compatible only with a point-to-multipoint access in-

stalled by your network provider. For more information on

multicell operation, ➔ page 81.

t Meaning: see footnote

After confirming - and thus activating - “Point to MP.”, se-

lect:

If you select multicell operation:

Enable or disable calls from and to multiple base stations.

The comfort mobile unit is idle. You will be prompted to

enter the system code in the course of this procedure

(default code: “0000”).

Service

System settings

Configuration

Point to MP.

Local op.

For operation with one base station (single-cell mode, de-

fault)

Multicell op.

For operation with more than one base station.

It is not advisable to enable calls between inter-

nal users across multiple base stations unless

your Gigaset 2060isdn is connected to a private

branch exchange.

The PBX must support this internal traffic. For

more information on point-to-multipoint opera-

tion ➔ page 17 and ➔ page 84

means: browse with

and

press

to confirm