Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationTEC Controller Unit Conditioner - Electronic Output Owner's Manual

Table Of Contents

Document No. 540-1026

May 1, 2014

TEC Unit Conditioner Controller

Item No. 540-1026 Rev. AA Page 1 of 5

Generic Controller I/O Layout. See Wiring Diagram for application specific details.

Control Applications

2040 and 2041

2050 through 2054

Product Description

These instructions explain how to field install or

replace a Siemens TEC Unit Conditioner Controller.

Product Numbers

Siemens TEC Unit Conditioner

Controller

540-110N

Shipping carton includes a controller assembly, a

mounting rail, and two self-tapping/drilling screws.

CAUTION

Keep the unit in its static-proof bag

until installation.

Otherwise, you run the risk of damage

to the printed circuit board from

electrostatic discharge.

Accessories

Low cost temporary temperature

sensor, 10K thermistor with RJ11

(1” long), that enables space

control if the permanent room or

duct sensor is not installed (pack of

25).

540-658P25

Duct Temperature Sensor, NTC

100K Ω Type 2, 3" Probe for

Commissioning only

QAM1035.008P50

Summary of content (5 pages)

PAGE 1
Installation Instructions Document No. 540-1026 May 1, 2014 TEC Unit Conditioner Controller Generic Controller I/O Layout. See Wiring Diagram for application specific details. CAUTION Control Applications Keep the unit in its static-proof bag until installation. 2040 and 2041 2050 through 2054 Otherwise, you run the risk of damage to the printed circuit board from electrostatic discharge.
PAGE 2
Document No. 540-1026 Installation Instructions May 1, 2014 Warning/Caution Notation WARNING Personal injury/loss of life may occur if you do not follow the procedures as specified. CAUTION Equipment damage or loss of data may occur if you do not follow the procedures as specified.
PAGE 3
Document No. 540-1026 Installation Instructions May 1, 2014 6. Plug the room temperature sensor cable into the RTS port. 7. Connect the power trunk. DO NOT apply power to the controller without first consulting the specialist. This TEC is designed to work with 2wire AC power (Neutral and Phase (hot) at 24Vac +/-20%. Use of the earth terminal is optional and if used it should be connected to CAUTION The controller’s DOs control 24 Vac loads only. The maximum rating is 12 VA for each DO.
PAGE 4
Document No. 540-1026 Installation Instructions May 1, 2014 Application 2041 – Variable Air Volume Pressure Dependent with Hot Water Reheat. Application 2050 – Two-Pipe Fan Coil Unit Cooling or Heating. Page 4 of 5 Application 2051 – Fan Coil Unit Cooling and Heating. Application 2052 – Fan Coil Unit Two-Stage Cooling and Electric Heat. Siemens Industry, Inc.
PAGE 5
Document No. 540-1026 Installation Instructions May 1, 2014 Application 2053 – Fan Coil Unit Two-Stage Cooling and Hot Water Heating. Application 2054 – Fan Coil Unit Cooling and Electric Heating or VAV Pressure Dependent with Electric Heating. Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as design improvements are introduced.