Data Sheet

ManualsBrandsSIEMENS ManualsElectrical Enclosure PeripheralsPower output module 6BK1943-2CA00-0AA0

Data sheet 6BK1943-2CA00-0AA0

SIPLUS HCS4300 POM4320 Rear panel mounting (IEC). Power

output module for mounting to the rear panel of the control cabinet.

With 9 outputs each max. 7680 W (for operating mode Half-wave

control: Depending on the inrush current of the load limitation to max.

4000 W)

General information

Product type designation POM4320

Installation type/mounting

Mounting type Backplane mounting

Mounting position vertical

Type of ventilation Self-ventilation

Supply voltage

Type of supply voltage AC

Rated value (AC) 400V

Relative negative tolerance 10%

Relative positive tolerance 30%

2nd rated value (AC) 480V

Relative negative tolerance 25%

Relative positive tolerance 8%

Line frequency

● Rated value 50 Hz

Yes

● Rated value 60 Hz

Yes

● Relative symmetrical tolerance

5%

6BK1943-2CA00-0AA0 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet 6BK1943-2CA00-0AA0 SIPLUS HCS4300 POM4320 Rear panel mounting (IEC). Power output module for mounting to the rear panel of the control cabinet. With 9 outputs each max. 7680 W (for operating mode Half-wave control: Depending on the inrush current of the load limitation to max.
PAGE 2
Mains buffering ● Recovery time after power failure, typ. 1s Connection method ● Design of electrical connection for supply voltage Terminal, 3-pin — Connectable conductor cross-sections, solid 1x (1.5 ... 50 mm²) — Connectable conductor cross-sections, finely stranded with wire end processing 1x (1.5 ... 35 mm²) — Connectable conductor cross-sections for AWG cables 1x (16 ... 1) Input voltage Design of the power supply Power supply via CIM Power Active power input, max.
PAGE 3
● Melting I2t value 250 A²·s ● Design of short-circuit protection per output Fuse 16 A ● Design of overvoltage protection Transil Diode Connection method ● Design of electrical connection at output for heating and fan Connector, 3-pole with spring-loaded connection — Connectable conductor cross-sections, solid 1x (0.2 ... 10 mm²) — Connectable conductor cross-sections, finely stranded with wire end processing 1x (0.25 ...
PAGE 4
Design of electrical isolation Optocoupler and/or protective impedance between main circuit and PELV between the outputs No Isolation Overvoltage category III Degree of pollution 2 EMC EMC interference emission Limit value in accordance with IEC 61000-6-4:2007 + A1:2011 Electrostatic discharge acc. to IEC 61000-4-2 4 kV contact discharge / 8 kV air discharge Field-related interference acc. to IEC 61000-4-3 10 V/m (80 ... 1 000 MHz), 3 V/m (1.4 ... 2.0 GHz), 1 V/m (2.0 ... 2.
PAGE 5
Altitude during operation relating to sea level ● Installation altitude above sea level, max. 2 000 m Relative humidity ● Operation at 25 ℃, max. 95 % ● Operation at 50 ℃, max. 50 %; 95 % at 25 °C, decreasing linearly to 50 % at 50 °C Vibrations ● Vibration resistance during operation acc. to IEC 60068-2-6 10 ... 58 Hz / 0.075 mm, 58 ... 150 Hz / 1 g ● Vibration resistance during storage acc. to IEC 60068-2-6 5 ... 8.5 Hz / 3.5 mm, 8.5 ...