User Manual

Installation

Installation procedure

Building Technologies A6V10062407_a_en

Fire Safety & Security Products 30.06.2013

3.4.13.3 Batch commands

The folder:

<installation folder>\Utilities\Bat

contains the following batch procedures:

NK8210ConfigurationTool.exe

This program initialises the IIS (Internet Information Service) for the NK8000 Web

Server to work. It should be used when the IIS software is installed after MK8000 and

requires a specific initialisation. The program should be started with a parameter (“-i” or

“–u”):

NK8210ConfigurationTool –i (to configure ISS for NK8000 Web Server)

NK8210ConfigurationTool –u (to remove the NK8000 Web Server configuration from

IIS)

Start/Stop servers

 Start_system.bat – Start servers

 START_Server.exe - Start Server application

 STOP_Server.exe - Stop Server application

After MK8000 software installation, Start and Stop commands are available on the

desktop, where two shortcuts are created, named

Start Server

and

Stop Server

respectively.

3.4.13.4 Registry scripts

The directory:

<installation folder>\Utilities\Reg

contains various registry-setting scripts. Only a few of them can be useful to you.

Namely:

DCOM XP Log

 DCOMXPLogEnable.reg

 DCOMXPLogDisable.reg

Enabling or disabling the event logs of DCOM call failures.

 Refer to Microsoft documentation about the

CallFailureLoggingLevel

registry key.

Communication event logging (technical support use only)

 EventLog_Router_Drivers.reg

Enable the event logging of communication and routing layers. Setting this mode will

result in a large part of Windows event logs being used for MK8000 technical

messages.

Do not enable this mode unless explicitly instructed by technical support.