User Manual

Tips for Integrating with an OPC client
6
Possible difficulties in integrating an OPC client
82
Building Technologies A6V10062407_a_en
Fire Safety & Security Products 30.06.2013
MM8000Server Properties - Security tab
Endpoints tab - MM8000Server Properties
We recommend leaving the Endpoints level to Default. This means that this server will
use the protocols that were set up on the Default Properties tab in the DCOM Config
utility. The Endpoints tab should look like the following figure:
MM8000Server Properties - Endpoints tab
Identity tab - MM8000Server Properties
You use this tab to determine which account you want to use to run the application.
There are four choices that the system uses to determine which account your DCOM
object will run under:
 The interactive user: the application will run using the security context of the user
currently logged onto the computer. If this option is selected and the user is not
logged on, then the application will not start.
 The launching user: the application will run using the security context of the user
who started the application. The launching user and the interactive user may be
the same (recommended).