User Manual

Installation
7
Building Technologies 008751_b_en MaxSys - MM8000 3.20 add-on.doc
Fire Safety & Security Products 09.2006
Fig. 2 Starting the add-on installation
2. Installing the Subsystem Tool
Composer requires that the tools are installed using a specific procedure.
Therefore, a small utility is also launched in order to add the MAXSYS Subsys-
tem Tool (ST) in to the Composer tool set.
The utility shows as illustrated in Fig. 3. Click ‘Install’ to proceed.
The installation procedure requires the account name and password of the
MM8000 “internal user”. In most cases, the default account parameters, provided
in the installation window, do not need to be changed. However, if during the pre-
vious MM8000 installation a different account was specified, then you need to
specify the customised username and password.
Fig. 3 Installing the MAXSYS Subsystem Tool
In few seconds, the tool is installed in Composer. The name of the new tool ap-
pears in the list (Fig. 4). At this point, click ‘EXIT’ to quit.