User Manual

Configuration
16
Building Technologies 008751_b_en MaxSys - MM8000 3.20 add-on.doc
Fire safety & Security Products 05.2005
Manual configuration
If you are not able to import the configuration, you can configure the MAXSYS sys-
tem by hand to reflect the actual control unit configurations.
The following list shows where different objects are located in the in the Composer
tree:
• PC6442 interface
– Physical tree (see below)
– Logical tree (see below)
– PC link (local service PC)
– Primary lines
– Infranet
– Users (a single object collects the status messages of all local users)
• Physical tree:
– PC6010 Main Board
– Zones
– Outputs: Bell, Auxiliary (AUX), Programmable (PGM)
– Backbone (external bus)
– Telephone line module (TLM)
– Power Supply (Main units and Auxiliary unit)
– Combus (internal bus)
– PC6108A zone expander
– PC6204 4-output module
– PC6216 16-output module
– PC6501 LCD keypad unit
– PC6400 serial interface units
– PC6820 2-door access control module
• Logical tree:
– Areas
– Linked zones
– Groups
– Linked Alarm and Seismic zones
Warning: manual configuration in Composer changes may be overwritten by subse-
quent import if the imported file does not include them too.
Linking the MAXSYS interface to the Communication network
1. Open NK822x sub-folders
Expand the NK8000 network folders until you reach the node that represents
the NK882x COM port that is physically connected to the MAXSYS.
2. Select the MAXSYS main node.
3. Drag and drop the MAXSYS node to the network COM port (see Fig. 15).
Not
e: Composer helps you recognise the valid link by displaying a shortcut
‘Link’ icon
instead of the circle ‘No-link’ icon .