Installation Instructions

Siemens Building Technologies
Fire Safety
P/N 315-050253-013
• Once the node number assignment and label have been accepted, the
following screen appears:
Figure 21 NCC-G Installation and Setup
• Press the NEXT button to continue with basic system configuration. The
following screen appears:
Figure 22 NCC-G/GL Site Information
• System Identification: Enter the name of the installed site, up to 52
characters long.
• Serial #: The number displayed is the version of the NCCG software.
• Command Seq #: The number displayed is the number of commands
executed since the system was installed.
• UL System: Select the NFPA 72 mode of operation. Refer to ther UL
System Type table at the end of this chapter for further information. The
possible selections are:
• NFPA 72 Local - Campus
• NFPA 72 Local - Highrise
• NFPA 72 Proprietary
All NCCs on a network system need to be set to the same UL system setting.