Installation Instructions

Siemens Building Technologies
Fire Safety
P/N 315-050253-03
• From the Windows Control Panel, select the Date/Time tool.
Check that the time, date and time zone settings are correct.
• From the Windows Control Panel, open the Printer tool and
add any additional printers required. Refer to the Windows XP™
manual for more information.
No printer or printer spool can be connected to LPT1. Doing so will prevent proper
operation of the paper out and printer off line function.
• From the Windows Control Panel, open the Display tool and
go to the Settings tab. Set the Desktop Area (screen resolution)
to a minimum of 1024x768 with a Color Quality as 16 bit or less.
Also, click the Advanced button and select Normal Size (96 DPI)
as the DPI setting in the General page. The NCC will function
properly with higher resolutions. If your monitor can accept a higher
Refresh frequency, set it to 75 Hz.
• If networking has been installed with XP, from the Windows
Control Panel, open Network Connections and click on the
Local Area Network icon. Click Properties in the general page.
Select Internet Protocol (TCPIP) and click Properties. Select
Use The Following IP Address. Enter the IP address: 192.168.1.1.
Enter the Mask 255.255.255.0. Press OK and exit the tool. (If you
are prompted about not having a WINS entry, ignore the message.)
• If you are using a touch screen, from the Windows Control Panel,
open the ELO Touchscreen tool and perform the required screen
calibration.
Close all windows and tools.
3. Initialize the Windows XP™ users that you have just created by logging on
to each one. Click Start> Log Off. When the logoff screen appears, click on
the Logoff Icon. Log on to "firefinder" by clicking on the FireFinder Icon, then
log on to "maintenance" and finally, log back on to "administrator".
4. Insert the NCC distribution CD into the CD ROM drive. The installation
should autostart. If it does not, find and run the file setup.exe in the root
directory of the CD. When prompted to continue, press ENTER.
5. The installer program will start to install the following packages in this order,
if they have not already been installed (NCC MP7 will always appear for an
upgrade):
Java Runtime Version 1.2.2
Sentinel Driver Version 7.4.0
Adobe Acrobat Reader 4.0
Microsoft IIS
NCC MP7
6. Java Runtime Version 1.2.2 - The following screen will appear (refer to Figure
3) to indicate the installation of the Java runtime package: