Network Router User Manual

Remote-SAT User's Guide

MC35_SAT_01_v02.00 Page 32 of 65 11.01.2002

1.4.9 AT^SSTGI Remote-SAT Get Information – Play Tone (32)

Write command

AT^SSTGI=32

This command is to be used upon receiving an unsolicited result code

^SSTN:32.

The ME has been instructed to generate an audible tone, and may pass to the

TA some information to support this.

Text and an Icon Identifier are passed to the TA for display to the user.

Response

^SSTGI: <cmdType>, <commandDetails>, <infoText>>, <tone>, <durationUnit>,

Parameters

<cmdType> 32 – Proactive command ID, see Table 1.

<commandDetails> This byte is RFU.

<infoText> String to accompany tone

<tone> Tone that the ME generates

Standard supervisory tones:

01 Dial tone

02 Called subscriber busy

03 Congestion

04 Radio path acknowledge

05 Radio path not available / Call dropped

06 Error / Special information

07 Call waiting tone

08 Ringing tone

ME proprietary tones:

10 General beep

11 Positive acknowledgement tone

12 Negative acknowledgement or error tone

0 Minutes

1 Seconds

2 Tenths of Seconds

<duration> Duration of tone, expressed in units (1-255)

<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.

bit 1: 0 icon is self explanatory and replaces text

1 icon is not self-explanatory and shall be displayed with

the text. Determined value only if associated icon id is not

0 (an icon exists).

bits 2-8: RFU

<iconId> 0-255, 0: no icon

Reference

Siemens

Note

Command is issued if the SIM application requests playing a tone with a length

more than 5 seconds.