Network Router User Manual

Remote-SAT User's Guide

MC35_SAT_01_v02.00 Page 34 of 65 11.01.2002

1.4.11 AT^SSTGI Remote-SAT Get Information – Get Inkey (34)

Write command

AT^SSTGI=34

This command is to be used upon receiving an unsolicited result code

^SSTN:34.

The TA is asked to prompt the user for an input, which is a single character.

Help can be requested by the user, if available.

Text and an Icon Identifier can be passed to the TA to display to the user.

Response

^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>

Parameters

<cmdType> 34 – Proactive command ID, see Table 1

<commandDetails> Unsigned Integer, range 0 – 255, used as a bitfield.

bit 1: 0 = digits (0-9, *, # and +) only

1 = alphabet set;

bit 2: 0 = SMS default alphabet (GSM character set)

1 = UCS2 alphabet

bit 3: 0 = character sets defined by bit 1 and bit 2 are

enabled

1 = character sets defined by bit 1 and bit 2 are

disabled and the "Yes/No" response is

requested

bits 4-7: = RFU

bit 8: 0 = no help information available

1 = help information available

<text> String as prompt for text.

<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.

bit 1: 0 = icon is self explanatory and replaces text

1 = icon is not self-explanatory and shall be

displayed with the text

Determined value only if associated icon id is

not 0 (an icon exists).

bits 2-8: = RFU

<iconId> 0-255, 0: no icon

Reference

Siemens

Note