Network Router User Manual

Remote-SAT User's Guide

MC35_SAT_01_v02.00 Page 39 of 65 11.01.2002

bits 2-8: = RFU

<titleIconId> 0-255, 0: no icon

<numOfItems> Number of menu items in the list

<itemId> Menu item identifier (1 – numOfItems)

<itemText> Title of menu item

<nextActionId> The next proactive command type to be issued upon

execution of the menu item. See Table 1

0: No next action information available.

<iconId> 0-255, 0: no icon

Reference

Siemens

Note

It is possible to issue AT^SSTGI during states IDLE, PAC and WAIT for this

Proactive Command without previously receiving an URC ^SSTN:<cmdType>,

see section “AT^SSTGI Remote-SAT Get Information – Generic Format”, pg.

23.

1.4.15 AT^SSTGI Remote-SAT Get Information – Setup Idle Mode Text (40)

Write command

AT^SSTGI=40

This command is mainly to be used upon receiving an unsolicited result code

^SSTN:40. However, please refer to note below.

It provides text, and optionally an icon, to be displayed by the TA when the

display is Idle.

Response

^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>

Parameters

<cmdType> 40 – Proactive command ID, see Table 1

<commandDetails> This byte is RFU.

<text> String to display when TA in Idle Mode.

<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.

bit 1: 0 = icon is self explanatory and replaces text

1 = icon is not self-explanatory and shall be

displayed with the text

Determined value only if associated icon id is

not 0 (an icon exists).