Network Router User Manual
Remote-SAT User's Guide
MC35_SAT_01_v02.00 Page 4 of 65 11.01.2002
1.5.2.13 AT^SSTR Remote-SAT Response – Set Up Menu (37)...................................54
1.5.2.14 AT^SSTR Remote-SAT Response – Set Up Idle Mode Text (40)....................55
1.5.3 Event Response Commands .............................................................................56
1.5.3.1 AT^SSTR Remote-SAT Event Response – Menu Selection (211)...................56
1.5.3.2 AT^SSTR Remote-SAT Event Response – User Activity (232)........................56
1.5.3.3 AT^SSTR Remote-SAT Event Response – Idle Screen Available (233)..........57
1.5.3.4 AT^SSTR Remote-SAT Event Response – Language Selection (235)............57
1.5.3.5 AT^SSTR Remote-SAT Event Response – Terminate Command (254) .........57
2 Appendix.....................................................................................................................................58
2.1 Appendix A – SAT Profile.................................................................................................. 58
2.2 Appendix B - UCS2 Character Set Options.......................................................................61
2.3 Appendix C – Language Codes......................................................................................... 63
0 Version History
This chapter reports modifications and improvements over previous versions of the document.
"Remote-SAT User’s Guide" Version MC35_sat_01_v0101a=> MC35_SAT_01_v02.00
Chapter / AT command Page What is new
1.1.4, Table 1 9 Section “Termination of Proactive Commands (URCs, TA
← ME ← SIM)”:
<cmdType> values 116 – 119 removed
1.4.3 AT^SSTGI Remote-SAT
Get Information – Set Up Event
List (5)
25 <eventList>: “range 0-255” removed
bit 9 – 16 (RFU) added
1.4.4 AT^SSTGI Remote-SAT
Get Information – Setup Call (16)
26 Description of write command modified
1.4.9 AT^SSTGI Remote-SAT
Get Information – Play Tone (32)
32 Parameters added
1.5 and 1.5.2.3 40
44
Syntax of write command response modified:
^SSTR: xy<TermQualifier>,<TerminationCauseText>
replaced with:
^SSTR: <pac>,<TermQualifier>,<TerminationCauseText>