Network Router User Manual

Remote-SAT User's Guide
MC35_SAT_01_v02.00 Page 54 of 65 11.01.2002
1.5.2.13 AT^SSTR Remote-SAT Response – Set Up Menu (37)
Write command
AT^SSTR=37,
<status>
Note:
As with every proactive command the TA is expected to acknowledge the
^SSTGI response with AT^SSTR to confirm that the proactive command has
been executed.
The response simply conveys, to the SAT, the information that the main menu
was received and set up on the user interface. It does not transmit any
information about a selected item, like in the case of AT^SSTR=36.
Once this command was executed the user can proceed as described in the
Chapter “AT^SSTR Remote-SAT Event Response – Menu Selection (211)”, pg.
56.
Response
OK
Parameters
<cmdType> 37 – Proactive command ID, see Table 1.
<status> Unsigned Integer, range 0-255
0 Command performed successfully (Proactive session will
end).
32 TA currently unable to process command
132 TA currently unable to process command because
screen is busy.
Reference
Siemens
Note