User's Manual

AT Command Set
MC35_ATC_01_V04.00 Page 88 of 238 02.04.2002
4.25 AT+CMER Mobile equipment event reporting
Test command
AT+CMER=?
Response
+CMER: (list of supported <mode>s),(list of supported <keyp>s),
(list of supported <disp>s),(list of supported <ind>s),(list of supported <bfr>s)
Parameter
See execute command
Read command
AT+CMER?
Response
+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>
Parameter
See execute command
Write command
AT+CMER=
[<mode>
[,<keyp>
[,<disp> [,<ind>
[,<bfr>]]]]]
Enables or disables the presentation of event reports to the TE in the form of
+CIEV Unsolicited Result Codes. See the <desc>> parameter for the list of
indicators.
Response
OK
Parameter
<mode> 0 discard CIEV unsolicited result codes
1 discard CIEV unsolicited result codes when TA-TE link is
reserved (e.g. in on-line data mode); otherwise forward them
directly to the TE
2 Buffer CIEV unsolicited result codes in the TA when TA-TE link
is reserved (e.g. in on-line data mode) and flush them to the
TE after reservation. Otherwise forward them directly to the
TE.
3 forward CIEV unsolicited result codes directly to the TE; TA-TE
link specific inband technique used to embed result codes and
data when TA is in on-line data mode
<keyp> 0 no keypad event reporting
<disp> 0 no display event reporting
<ind> 0 no indicator event reporting
2 indicator event reporting using result code
+CIEV: <desc>,<value>
<desc> indicates the indicator’s name and <value> is the new
value of this indicator.All indicator events shall be directed from
TA to TE.
<bfr> 0 TA buffer of unsolicited result codes defined within this
command; is cleared when <mode> 1...3 is entered
<desc> values reserved by this ETS and their <value> ranges:
"battchg" battery charge level (5 only = no level measuring)
"signal" signal quality (0-7 or 99 if not measurable)
"service" service availability (0-1)
"sounder" sounder activity (0-1)
"message" unread message (0-1)
"call" call in progress (0-1). Voice und data calls only.
"roam" roaming indicator (0-1)
"smsfull" a short message memory storage in the MT has
become full (1) or memory locations are available
(0); i.e. the range is (0-1)