User manual

ManualsBrandsSiemens ManualsNetwork RouterSiemens Network Router MC35

100

AT Command Set

MC35_ATC_01_V05.00 Page 98 of 256 15.07.2002

4.26 AT+CMER Mobile equipment event reporting

Test command

AT+CMER=?

Response

+CMER: (list of supported <mode>s),(list of supported <keyp>s),(list of supported

<disp>s),(list of supported <ind>s),(list of supported <bfr>s)

Parameters

See write command

Read command

AT+CMER?

Response

+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>

Parameters

See write command

Write command

AT+CMER=

[<mode>

[,<keyp>

[,<disp> [,<ind>

[,<bfr>]]]]]

The Execute command enables and disables the presentation of Unsolicited Re-

sult Codes for event reporting. MC35 supports only the type +CIEV (indicator

event reporting). If enabled the +CIEV URCs are sent whenever the value of an

indicator changes.

Response

Parameters

<mode> 0 Discard CIEV Unsolicited Result Codes

1 Discard CIEV Unsolicited Result Codes when TA-TE link is

reserved (e.g. in on-line data mode); otherwise forward them

directly to the TE

2 Buffer CIEV Unsolicited Result Codes in the TA when TA-TE

link is reserved (e.g. in on-line data mode) and flush them to

the TE after reservation. Otherwise forward them directly to the

TE.

3 Forward CIEV Unsolicited Result Codes directly to the TE; TA-

TE link specific inband technique used to embed result codes

and data when TA is in on-line data mode

<keyp> 0 No keypad event reporting

<disp> 0 No display event reporting

<ind> 0 No indicator event reporting

2 Indicator event reporting using result code

+CIEV: <desc>,<value>

<desc> indicates the indicator’s name and <value> is the new

value of this indicator. All indicator events shall be directed

from TA to TE.

<bfr> 0 TA buffer of Unsolicited Result Codes defined within this

command; is cleared when <mode> 1...3 is entered

Unsolicited Result Code:

+CIEV: <desc>,<value>

Parameters

<descr> values and their <value> ranges:

"battchg" Battery charge level (0-5),

where (0-5) means 0, 20, 40, 60, 80 or 100 per

cent of the the remaining battery capacity. If no

battery is connected to the ME, then the value will

be always equal to 5. See also Chapter 8.5.