User's Manual
Table Of Contents
- 6 Antennas
- 7 RF300 transponder
- 7.1 Memory configuration of the RF300 transponders
- 7.2 SIMATIC RF320T
- 7.3 SIMATIC RF330T
- 7.4 SIMATIC RF340T
- 7.5 SIMATIC RF350T
- 7.6 SIMATIC RF360T
- 7.7 SIMATIC RF370T
- 7.8 SIMATIC RF380T
- 8 ISO transponder
ISO transponder
8.4 MDS D124
SIMATIC RF300
System Manual, 07/2016, C79000-G8976-C345-0x
265
6GT2600-0AC10
• at +180 ℃: Tested up to 5000 hours or
3000 cycles
• During transportation and storage • -40 to +125 ℃
Degree of protection to EN 60529
• IP68
2 hours, 2 bar, +20 °C
• IPx9K
steam jet: 150 mm; 10 to 15 l/min; 100 bar; 75
°C
Shock-resistant to EN 60721-3-7 class 7M3
100 g
1)
Vibration-resistant to EN 60721-3-7, class 7M3
20 g
1)
Torsion and bending load
Not permitted
Design, dimensions and weight
Dimensions (Ø x H)
4 x 5.2 mm
Weight
5 g
Type of mounting
• 1 x M3 screw
2)
≤ 1 Nm
• Glued
• With spacer
1)
The values for shock and vibration are maximum values and must not be applied continuously.
2
) To prevent it loosening during operation, secure the screw with screw locking varnish.
8.4.5
Use of the MDS D124 in hazardous area
The mobile data memory MDS D124, device group II, category 1G or 1D may be installed
and operated in zones 0, 1 and 2 or in the zones 20, 21 and 22.
The following requirements of the 94/9/EC directive are met:
● EN 60079-0:2009
● EN 60079-11:2007
● EN 61241-11:2006
● EN 60079-26:2007
When used in hazardous areas, the MDS D124 must not be operated with field strengths > 5
A / m to avoid impermissible heating. This is not the case with readers from the SIMATIC RF
range (MOBY D, RF200 and RF300).