User Guide

Global Positioning System (GPS)
Rev 3.0B Feb.08 90
Sending Reports Automatically
Remote
YoucanconfigurethePinPointXtosendreportsbasedona
timeintervalandonthemovementofavehicle(basedonit’s
positionfromonetimetothenext).
Figure 10-7: AceManager : PinPoint - *PPTIME, *PPDIST, *PPTSV,
*PPMINTIME
• *PPTIME‐Locationreportsenteverysettimeinterval
(seconds).
• *PPDIST‐Locationreportsentonlyifthepositionismore
thanthesetdistance(x100meters).
• *PPTSV‐Locationreportsentifthevehiclehasbeenin
onelocation(stationary)formorethanasettimeinterval
(minutes).
• *PPMINTIME‐Locationreportsentbesentatnoless
thanthistimeinterval(seconds).
Note: If you’re implementing both a time interval and distance interval
for reports, the PinPoint X will use the timer which expires first. The
reporting interval can impact your data usage. If the interval is set
frequently, you may want to have a high usage or unlimited data plan.
Tip: One mile is approximately 1600 meters. 1000 meters is one
kilometer.
Local
Ifyouaresendingreportsonthelocalserialport,and/orifyou
wantthemsentautomatically,youwillneedtoset*PPLATS.
Thetimeinterval,justasfor*PPTIME,isinseconds.
Figure 10-8: AceManager : PinPoint - *PPLATS
Report Delay on Power-Up
ThePinPointXcanbe configuredtowaitaspecificamountof
timeafterinitializationbeforeanyreportsaresent.Configure
#IGforthedesiredwaitinseconds.