User Guide

Global Positioning System (GPS)
Rev 3.0B Feb.08 96
Tip: If the PinPoint X is using a dynamic IP, *PPDEVID needs to be
enabled.
Odometer Data in Reports
Whentheodometerreportisenabled,thePinPointXwill
calculatedistancebetweenreportsbasedonGPSdata.The
modem’sodometercalculationscanbeincludedintheRAP
message.
Figure 10-20: AceManager : PinPoint - *PPODOM, *PPODOMVAL
• *PPODOMenablestheodometerreporting.
• *PPODOMVAListhecurrentodometerreadinginthe
PinPointX.Youcansetthistoanumbertooffsetthe
odometercalculation,suchasone‐timemanualsynchroni
‐
zationofthePinPointXodometerwiththecurrentvehicle
odometer.
Note: The odometer calculations of the PinPoint X may not match the
odometer in the vehicle itself. The PinPoint X odometer is not
connected to the vehicle’s, it is entirely based on calculations of GPS
readings.
I/O Event Reports
YoucanconfigurethePinPointXtosendreportstotheAVL
Hostbasedonthestateofthedigitalinputs.
Tip: Setting up the I/O port hardware is covered in the Inputs, Relay
Outputs, and Power Status chapter.
Enable*PPINPUTEVTtohaveeventssenttotheHostserver.
Figure 10-21: AceManager : PinPoint - *PPINPUTEVT
COM1000support