User Guide

Global Positioning System (GPS)
Rev 3.0B Feb.08 101
TAIP Emulation Configuration
TheTAIPemulationfunctionalityallowsthePinPointXto
operateinalimitedmannerwithclientswhichonlyunder
‐
standtheTrimbleASCIIInterfaceProtocol(TAIP).This
emulationisenabledbysettingtheGPSreportformat,
directingthemodemtolistenforTAIPmessages,and
disablingRAPformattedmessagestothesameinterface.
TAIP ID
TAIPmessagescanbeconfiguredtosendtheuserspecified
identificationnumber(ID).Thisgreatlyenhancesthe
functionalcapabilityoftheunitinanetworkenvironment.Set
theIDusing*PPTAIPID.
Figure 10-32: AceManager : PinPoint - *PPTAIPID
TAIP Command Emulation
WithTAIPemulation,thePinPointXwilllistenforTAIP
messagesonport21000.SettheGPSReportType,*PPGPSR,to
yourpreferredTAIPdataformat.
Figure 10-33: AceManager : PinPoint - *PPGPRSR
• F0‐TAIPdata(LN):latitude,longitude,altitude,the
horizontalandverticalspeed,andheading.
• F1‐CompactTAIPdata(PV):latitude/longitude,speed,
andheading.
Caution: When TAIP emulation is enabled, RAP will be disabled and
no RAP messages or commands will be sent or received on that port.
Supported TAIP Commands
TheTAIPemulationwillacceptthefollowingTAIPmessage
types: