User Guide

Global Positioning System (GPS)
Rev 3.0B Feb.08 102
• SRM(SetReportingMode)allowstheclienttosetthe
reportingmodeconfiguration.Thereportmodeconfigu
‐
rationisnotstoredinnon‐volatilememoryand such
shouldberesentuponaunitreset.Thisbehavioremulates
thatspecifiedinTAIPspecifications.
• QRM(QueryReportingMode)reportsthereportingmode
configuration(returnsan“RRM”message).
• SID(SetID)allowstheclienttosettheTAIPID
(AT*PPTAIPIDcanalsobeusedtosettheTAIPID).The
TAIPID,whensetwitha“S ID”message,willbewrittento
non‐volatilememory.
• QID(QueryID)reportstheTAIPID(returnsan“RID”
message).
• DPVconfiguresautomaticreportingofPV(Position/
Velocity)reportsbasedondistancetraveledanda
maximumtime.Thedeltadistancevaluespecifiedinthe
messageisconvertedtohundredsofmetersandstoredas
*PPDIST.Themaximumtimeintervalisstoredas
*PPTIME.Currentlytheminimumtimeandepochvalues
are
ignored.
• FPVconfiguresperiodicreportingofPV(Position/
Velocity)reports.Thetimeintervalfromthemessageis
storedat*PPTIME.Currentlytheepochvalueisignored.
• QPV(QueryPositionVelocity)respondswithaPV
(Position/Velocity)report.
TheTAIPemulationwillgeneratethefollowingreportscorre‐
spondingtotheappropriateevent(eitheraqueryforit,echoed
duetoaset,orduetoanautomaticreportingevent):
• RRM(ReportReportingMode)reportsthereporting
modeconfiguration.
• RID(ReportID)reportstheTAIPID.
• RPV(ReportPosition/Velocity)reportsPosition/Velocity.
Messages Over-the-Air (Remote)
ToconfigurethePinPointXtosendNMEAreportstoaremote
server,youwillneedtoset3commands:*PPIP,*PPPORT,and
*PPGPSR.
a. Set*PPIPand*PPPORTtotheIPaddressandportof
theservertowhichyouwantthereportssent.
Figure 10-34: AceManager : PinPoint - *PPIP/*PPPORT