User Guide

Configuration Commands
Rev 3.0B Feb.08 119
*NETIP?
Note: If there is no current
network IP address, 0.0.0.0 may
be displayed.
ThecurrentIPaddressofthemodemreportedbytheinternal
module,generallyobtainedfromAT&T.Thisistheaddress
cancontactthePinPointXfromtheInternet.
Tip: Use *NETALLOWZEROIP if you need to allow the display of an
IP ending in a zero.
*NETOP?
Thecurrentcellularcarrierfromthemodemʹsfirmware
version,forexample,AT&T.
*NETRSSI?
ThecurrentRSSI(ReceiveSignalStrengthIndicator)ofthe
PinPointXasanegativedBmvalue.
Tip: The same information is displayed with the command S202?.
*NETSERV?
Thetypeofservicebeingusedbythemodem,forexample
Tech.
*NETSTATE?
Thecurrentnetworkstate:
• ConnectingToNetwork:ThePinPointXisintheprocess
oftryingtoconnecttothecellularnetwork.
• NetworkAuthenticationFail:Authenticationtothe
cellularnetworkhasfailed.Verifysettingstoactivatethe
PinPointX.
• DataConnectionFailed:ThePinPointX failedtoconnect,
anditisnowwaitingasettimeintervalbeforeitattempts
toreconnect.VerifysettingstoactivatethePinPointX.
• NetworkNegotiationFail:Networkconnectionnegoti‐
ationfailed.Thisisusuallytemporaryandoftenclearsup
duringasubsequentattempt.
• NetworkReady:ThePinPointXisconnectedtothe1x
cellularnetworkandreadytosenddata.
• NetworkDormant:ThePinPointXisconnectedtothe1x
cellularnetwork,butthelinkisdormant.Itwillbewoken
upwhendataissentorreceived.
• NoService:Thereisnocellularnetwork detected.