User Guide

Configuration Commands
Rev 3.0B Feb.08 122
Misc (Miscellaneous)
Thecommandsofthe“Misc”groupareavarietyofcommands
thatdon’tdirectlyfitinothercategories.
Figure 1-5: AceManager : Misc
+++
Note: +++ is not proceeded by
AT nor does it require a carriage
return (enter). There must be an
idle time (set by S50) on the
serial port before and after this
command.
ATEscapesequence.IfthePinPointXisinadatamode(any
modeotherthanPassThru),thiscommandcausesthemodem
tore‐enterATcommandmode.The“+”isASCII0x2B.
+++ is
not available in AceManager.

Tip: DAE=1 disables the +++ command.
A/
Note: A/ is not proceeded by AT. Re‐executelastcommand.A/isnotusedinAceManager.
A
Manuallyansweranincomingconnection.Aisnotusedin
AceManager.
D[method][d.d.d.d][/ppppp] or D[method][@name][/
ppppp]
DialaconnectiontoaremoteIPandPortusingmethod.
CannotbeconfiguredinAceManager.
• method=P:EstablishaUDPconnection
• method=T:EstablishaTCPconnection
• method=N:EstablishaTelnetconnection