User Guide

Configuration Commands
Rev 3.0B Feb.08 127
Figure 1-7: AceManager : Serial
En
ToggleATcommandechomode.
• n=0:EchoOff.
• n=1:EchoOn.
Note: With more than one connection types (serial, Telnet, and USB)
the echo command can be set differently on each interface.
Qn
TheATquiet‐modesetting.Ifquietmodeisset,therewillbe
noresponsestoATcommandsexceptfordataqueried.
• n=0:Off(Default).
• n=1:Quiet‐modeon.
S3=n
Thestandardendoflinecharacterusedtoindicatetheendof
anATcommand.Thischaracterisalsousedasthecarriage
returncharacterforframingresponsesandresultcodesin
commandstate.CannotbeconfiguredinAceManager.
• n=0‐127(ASCIIcharacternumber)
S4=n
Thestandardlinefeedcharactersentbythemodemtothehost
attheendofaresponseorreturncodeincommandstate.
CannotbeconfiguredinAceManager.
• n=0‐127(ASCIIcharacternumber)