User Guide

Configuration Commands
Rev 3.0B Feb.08 131
RS232voltagelevels:
Positive = Network coverage.
Negative = No coverage.
Tip: Flow control (AT\Q) will override this indication, so if you want to
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
*NUMTOIP=n
Convert12digit numbertoIP.
• n=0:Useasname.
• n=1:UseasIPaddress.
*PPPNOCARRIER=n
Providesa“NoCarrier”messagetoadeviceconnectedtothe
serialportusingPPPorCHAPwhenthecellularconnection
becomesunavailable.
• n=0:Disabled(Default).
• n=1:Enabled.
TCP
ThisgroupincludescommandsspecifictoTCPserialcommu‐
nications.
Figure 1-8: AceManager : TCP
S0=n
ThisregisterdetermineshowthePinPointXrespondstoan
incomingTCPconnectionrequest.ThePinPointXremainsin
ATCommandmodeuntilaconnectionrequestisreceived.
DTRmustbeasserted(S211=1or&D0)andthePinPointX
mustbesetforasuccessfulTCPconnection.ThePinPointX
will
senda“RING”stringtothehost.A“CONNECT”sentto
thehostindicatesacknowledgementoftheconnectionrequest
andtheTCPsessionisestablished.