User Guide

Configuration Commands
Rev 3.0B Feb.08 133
*ENQ=n
OutputsanENQ[0x05]aftertheTCPCONNECTdelayedby
theDelayConnectResponsetime(S221).
• n=0:Disabled(Default).
• n=1:EnableENQonCONNECT.
UDP
ThisgroupincludescommandsspecifictoUDPserialcommu‐
nications.
Figure 1-9: AceManager : UDP
AIP=n
AllowIPaddress.
• n=0:AllowonlytheIPaddressspecifiedinS53toconnect
whenUDPautoanswerisenabled(S82=2).
• n=1:AllowanyincomingIPaddresstoconnectwhen
UDPautoanswerisenabled(S82=2).
Note: Always subject to any Friends filters that may be defined.
HOR=n
Half‐OpenResponse‐InUDPautoanswer(half‐open)mode.
• n=0:NoresponsecodeswhenUDPsessionisinitiated.
• n=1:RINGCONNECTresponsecodessentoutseriallink
beforethedatafromthefirstUDPpacket.
Note: Quiet Mode must be Off.