User Guide

Configuration Commands
Rev 3.0B Feb.08 135
*UALL=n
AcceptsUDPpacketsfromanyIPaddresswhenaUDP
sessionisactive.IfthereisnoUDPsessionactive,anincoming 
UDPpacketwillbetreatedaccordingtotheUDPautoanswer
andAIPsettings.
• n=0:Noeffect(Default).
• n=1:AcceptUDPdatafromallIPaddresseswhenina
UDPsession.
*UDPLAST=n
Note: *UDPLAST does not
change the S53 setting in
NVRAM. If the modem is reset,
the original S53 setting will be
restored from NVRAM.
Ifenabled,setsS53tothelastacceptedIPaddressthrough
UDPautoanswer.ThiscanbeusedinconjunctionwithMD3
sothatwhenthereisnoUDPsession,newethernethostdata
willcauseaconnectiontoberestoredtothelastIPaccepted
throughUDPautoanswer.
• n=0:DoesnotchangeS53setting.(Default).
• n=1:SetS53tothelastacceptedIP.
*USD=n
Waitsthe specifieddelaybeforesendingthefirstUDPpacket
andthesubsequentUDPpacketsouttotheportEthernet.
• n=0:NoUDPpacketdelay(Default ).
• n=1‐255:Delayin100msunits,from100msto25.5sec.
DNS
Thisgroupincludescommandsspecifictothemodembeing
abletousedomainnamesinsteadofIPaddressesforother
configurationoptions.
Figure 1-10: AceManager : DNS
*DNSn=d.d.d.d
QueriestheDNSaddresses.Yourcellularcarrierprovidesthe
DNSaddresseswhileyourmodemisregisteringontheir
network.
• n=1or2:FirstandsecondDNSaddress.
• d.d.d.d=IPaddressofdomainserver.