User Guide

Configuration Commands
Rev 3.0B Feb.08 139
requests.n=0:Disabled.TheRavenXwillnotsendout
repliestoDHCPrequests.
Tip: For PPPoE, set *DHCPSERVER=0.
*HOSTAUTH=n
HostAuthenticationMode:UsePAPorCHAPtorequestthe
userloginandpasswordduringPPPorCHAPnegotiationon
thehostconnection.Theusernameandpasswordsetin
*HOSTUIDand*HOSTPWwillbeused.
• n=0:DisablePAPorCHAPrequest(Default).
• n=1:PAPandCHAP.
• n=2:CHAP
Tip: For PPPoE, set *HOSTAUTH=1 or *HOSTAUTH=2.
*HOSTNETMASK=n.n.n.n
Subnetmaskforthehostinterface.Allowscommunication
withasubnetbehindthehostinterface.
• n.n.n.n=subnetmask,example255.255.255.0.
*HOSTPEERIP=d.d.d.d
SetorquerytheIPaddressthatcanbeusedtodirectlycontact
thePinPoint Xonceacellularconnectionisestablished.Ifthis
valueisnotspecified,192.168.13.31willbeused.
• d.d.d.d=localorpeerIPaddressofthemodem.
Note: This is not normally used nor needed by user applications.
*HOSTPRIVIP=d.d.d.d
SetorquerytheprivateIPaddressthatistobenegotiatedby
the1xconnectionif*HOSTPRIVMODE=1.
• d.d.d.d=IPAddress
*HOSTPRIVMODE=n
Setorquerywhetheraprivateorpublic(network)IPistobe
usedwhentheHostinitiatesa1xconnectiontothemodem.
• n=0:Public(network)IPMode:WhentheHostinitiatesa
PPPconnection,thehostwillbegiventhenetworkIP
addressthatwasobtainedfromthecellularcarrierwhile
registeringonthenetwork.If thenetworkissuesanewIP