User Guide

Configuration Commands
Rev 3.0B Feb.08 143
*SMTPSEND=email[body]
Sendsanemailtotheaddressspecified,followedbythebody
oftheemailmessage.Theemailmessageisterminatedand
sentbyenteringa.orCtrl‐Zonanemptyline.Cannotbe
configuredwithAceManager.
• email=emailaddress
• body=messagebody
*SMTPSTATUS?
ReturnsthestatusofthelastissuedSMTPmessage
(*SMTPSEND).Ifnostatusisavailable0isreturned.Once
read,thestatusisclearedout.Thestatuscodesreturnedcome
fromtheSMTPservertowhichthatthemodemsentthe
request.Unlessthereceivingserverisnotstandard,they
follow
theRFCforSMTP.CannotbeusedwithAceManager.
Example:
354 = send in progress
250 = sent ok
*SMTPSUBJ=subject
Allowsconfigu rationofthedefaultSubjecttouseifoneisnʹt
specifiedinthemessagebyprovidinga“Subject:xxx”lineas
theinitialmessageline.
• subject=messagesubject
*SMTPUSER=user
TheemailaccountusernametoauthenticatewiththeSMTP
server(*SMTPADDR)forsendingemail.
• user=username(maximum:40characters).
Note: Not required to use SMTP settings but may be required by your
cellular carrier.
Remarque :