User Guide

Configuration Commands
Rev 3.0B Feb.08 147
• n=minutes
*TPORT=n
Setsorqueriestheportusedfor theATTelnetserver.If0is
specified,theATTelnetserverwillbedisabled.Thedefault
valueis2332.
• n=0:Disabled.
• n=1‐65535
Tip: Many networks have the ports below 1024 blocked. It is recom-
mended to use a higher numbered port.
*TQUIT
Disconnectsthetelnetsession.NotavailableinAceManager..
Low Power
ThePinPointXwillputitselfintoalowpowerusingmode
whenconfiguredeventsoccur.LowPowermodeisessentially
astandbymodewhichusesminimalpowe rwhilebeingready
to“comealive”quickly.
Figure 1-16: AceManager : Low Power
PTMR=n
Numberof minutesafteroneofthepowerdownevents(VTLG
orDTRP)happensuntilthePinPointXentersthelowpower
mode.IfDTRPandVLTGareboth0(zero),thissettingdoes
nothing.
• n=0‐255minutes
Note: There is always a minimum of 1 minute between power down
event and actual shutdown (to give the PinPoint X time to prepare);
entering zero will not power down the modem immediately, but after