User Guide

Configuration Commands

Rev 3.0B Feb.08 152

ImmediatelyissueGPSreporttotheATSserverIPandport.

NotavailableinAceManager.

*PGPS=n

SendNMEAGPSstringsoutseriallink.SimilartoATGPS

exceptthatthe*PGPSvaluecanbesavedtoNVRAMsothatit

willcontinuetooperateafterresets.

• n=0:Disabled

• n=1:SendNMEAGPSstringsoutseriallink.

• n=2:SendNMEAGPSstringsouttheUSBport.

• n=3:SendNMEAGPSstringsoutboththeserialandthe

USBport.

*PGPSF=n

PersistantGPSfrequency

• n=numberofsecondsperreport

MaxValue:65535upto18hours

*PPCOM1000=n

EnablessupportforextrainputsfromaCOM1000.

• n=0:Disable

• n=1:Enable

Tip: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are

enabled, the PinPoint X digital inputs will be reported and the

COM1000 inputs will be ignored.

*PPDEVID=n

WhetherornotthePinPointXshouldincludethe64‐bitdevice

IDinitsGPSreports.*PPDEVIDMUSTbe1ifthemodemuses

aDynamicIP.

• n=0:DisableID.

• n=1:Enable/displayID.

*PPDIST=n

GPSReportDistanceIntervalin100MeterUnits(kilometer).1

mileisapproximately1600kilometers.

• n=0:Disabled

• n=1‐65535