User Guide

Configuration Commands
Rev 3.0B Feb.08 155
*PPMINTIME=n
Specifiestheminimumamountoftimebetweenreports
generatedduetoeitherthetimeinterval(*PPTIME)orthe
distanceinterval(*PPDIST).Thisisusefultolimitnetwork
trafficandmakemoreefficientuseofbandwidth.Thiscanbe
usedinconjunctionwithstoreandforward.Theminimum
valuewhichthissetting
cantakedependsonthepoliciesofthe
carrier.
• n=0:Disabled
• n=1‐65535seconds
*PPODOM=n
Enableodometerreporting.
• n=0:Disabled(default)
• n=1:Enabled
*PPODOMVAL=n
ThecurrentodometervalueofthePinPointX.Thevalueisin
meters.Maximumvalueisapproximately4.3billionmeters
(2.5millionmiles).1mileisapproximately1600meters.
• n=meters
*PPPORT=n
PortwhereGPSreportsaresent.
• n=1‐65535
*PPREPORTINPUTS=n
Enableinputreporting.
• n=0:Disabled
• n=1:Enabled
Note: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are
enabled, the PinPoint X digital inputs will be reported and the
COM1000 inputs will be ignored.
*PPSIMPLETO=n
Definesthelinearback‐offbasenumber.Notavailablein
AceManager.
• n=0:Disabled
• n=5‐255