User Guide

Configuration Commands
Rev 3.0B Feb.08 156
*PPSNF=n
StoreandForwardwillcauseGPSreportstobestoredupifthe
PinPointXgoesoutofnetworkcove rage.Oncethevehicleisin
coveragetheGPSreportswillbesentenmassetotheserver.
• n=0:Disabled
• n=1:Enabled(default)
*PPSNFB=n
StoreandForwardBehavior.When*PPSNF=1,thetypeof
StoreandForwardbehaviorisdefinedby:
• n=0:NormalStoreandForward.Dataisstoredwhenthe
PinPointXisoutofcellularcoverage;whenthePinPointX
isincoverage,dataissenttoserverassoonaspossible.
• n=1:Datasentonlywhenpolled.Dataisstoreduntil
polledusingthePollcommandsentbyaserver.
• n=2:GroupedReports.Dataisstoreduntilthedesired
minimumnumberofreports(see*PPSNFM)has been
stored.Thedata isthensenttotheserveringroupswithat
leastthespecifiednumberofreports.
*PPSNFM=n
StoreandForwardMinimumReports.Specifiestheminimum
numberofreportsthatmustbestoredbeforetheyare
forwardedtotheserver.Thedataisthensenttotheserverin
packetsthatcontainatleastthisnumberofreports.
• n=0‐255
*PPSNFR=n
StoreandForwardReliability:GPSreportswillberetrans‐
mittedifnotacknowledgedbytheserver.
• n=0:Disabled
• n=1:ReliablemodeenabledforRAPmessages
• n=2:Simplereliablemode
*PPTAIPID=nnnn
Sets/queriestheTAIPID.ThisIDisreturnedinTAIPreportsif
ithasbeennegotiatedwiththeTAIPclient.Thisvalueisonly
usedinconjunctionwithTAIPemulationmode(*PPGPSR=F0).
• nnnn=TAIPID(4characters)
*PPTCPPOLL=n
SpecifiestheporttolistenonforTCPGPSreportpolling.The
requesttothisportneedstocomefromthesameIPaddressin
*PPIP.