User Guide

Configuration Commands
Rev 3.0B Feb.08 159
• n=1‐2Inputnumber
• s=OPEN or CLOSED
Edge/HSDPA
ThisgroupincludescommandsspecifictoHSDPA,EDGEand
GPRS.Ifyouarenotconnectingtoamodemwhichuses
HSDPA,EDGE,orGPRS,youwillnotseethisgroupinthe
menu.
Figure 1-21: AceManager : EDGE/HSDPA
*NETAPN=apn
EasyentryoftheAPN.Ifleftblank,themodemwillattemptto
usethedefaultsubscribervalueasdefinedbytheaccount.
• apn=accesspointname
+CGQMIN
MinimumAcceptableQualityofServiceProfile.Change
shouldbeatcarrierʹsrequest.Normallynotrequiredtobe
changed.
+CGQREQ
SetQualityofServiceProfile.Changeshouldbeatcarrierʹs
request.Normallynotrequiredtobechanged.
+COPS=mode,[format][,oper]
Manuallyspecifyanoperator.Referalsoto*NETOP.
• mode=0:Automatic‐anyaffiliatedcarrier[default].
• mode=1:Manual‐useonlytheoperator<oper>specified.
• mode=4:Manual/Automatic‐ifmanualselectionfails,
goestoautomaticmode.
• format=0:Alphanumeric(ʺnameʺ).