User Guide

Configuring your PinPoint X
Rev 3.0B Feb.08 39
4. Connected
Figure 5-16: HyperTerminal : TCP/IP connected
a. Ifyouarepromptedforapassword,enter12345.
Tip: You will not be prompted for a password if you connect using a
COM port.
b. TypeATandpress Enter.Youshouldgetareplyof
“OK”or“0”.
c. Toseewhatyouare typingasyoutypeit,youwill
needtoturnontheechoand verbosemode.Type
ATE1V1andpressEnter.
d. Ifyougetareplyof“OK”,thenyouenteredthe
commandsuccessfully.Ifyougetareplyof“0”or
“ERROR”,tryenteringthecommandagain.
AT Commands
Whenusingaterminalapplication,youwillneedtomanually
typeineachcommand.
• Formostcommands,whenyouareenteringthemusinga
terminalconnection,youwillneedtoprefacethe
commandwithAT(exceptionsarenoted),i.e.AT Awhich
islistedasA.
• Somecommandshavespecificparameterswhileother
commandswilltakewhateveryoutype. 