Satellite Radio User Manual

55
System Configuration Commands
These commands are used by the system administrator to set up the specific behavior of
the system. Typically these commands are defined once and don’t change. In most
cases the default system configuration parameters supplied with the control system will
be used unaltered by the system administrator.
Unlock code management commands
Configuring basic parameters – ID, prefix, location ID
Macro programming commands
CW Telemetry Commands
Port personalities and link map
Group configuration and management
Digital Pot Controls
Command Telemetry Routing
Radio normal behavior
Remote base radio configuration
Basic configuration – ID, prefix, location ID
Internal Hardware System Commands
Reset processor
Firmware code version
Reset counter management
Query number of ports
Query firmware CRC values
Save / restore configurations to / from EEPROM
Low level EEPROM read / write commands
Macro table block read / write