User manual

USER MANUAL

Page

at the top of the screen. The one without any mark indicates the point with maximum

temperature on the screen, and its temperature is shown in the right corner above the

palette.

• Press the ▲

▼

◄

► Keys to move the spot indicator to the desired position

on the display screen - the corresponding spot temperature is shown at the top of the

screen.

• Press the M Key to move to the next active spot indicator on the display screen and

repeat the previous procedure until all spot indicators are in the desired positions.

• The operator may choose between displaying one or four measurement spots. This

is accomplished by pressing the M Key to bring up the main menu, then pressing the

▼ Key to highlight the Setup option, and then selecting “Analysis” by pressing the M

or OK Keys.

• Under the heading “Mul Spot/Area”, you can select between “on” or “off” by pressing

the ◄

► Keys, then select your choice by pressing the M or OK Keys. Note,

only one spot is displayed in the “off” position.

• Press the C Key to exit and return to the saved image.

Line Sub-menu

• Line analysis is only available on saved images.

• Press the M or ► Keys to enter the “Analysis” menu. Press the ▼ Key to highlight

and select “Line”, then press the M or OK Key.