User Manual

18
CLEANING
Sierra equipment is sturdily constructed of the best materials and is designed to provide durable service when treated
with ordinary care. To expect the best performance, your equipment must be maintained in good condition and
cleaned daily. Naturally, the periods for this care and cleaning depend on the amount and degree of usage.
Following daily and periodic maintenance procedures will enhance long life for your equipment. Climatic conditions
(such as salt air) may require more thorough and frequent cleaning or the life of the equipment could be adversely
affected.
The oven interior is finished with a porcelain enamel coating. “Spillovers” should be cleaned from the interior bottom
surface as soon as possible to prevent carbonising and a burnt-on condition. Grease or any residue should be
cleaned from interior surfaces as soon as it accumulates.
FOR YOUR SAFETY, DISCONNECT THE POWER SUPPLY TO THE APPLIANCE
BEFORE CLEANING.
WHEN CLEANING THE BLOWER WHEEL, BE SURE TO HAVE THE POWER SWITCH IN THE
“OFF” POSITION.
DAILY CLEANING
1. Turn the power switch to OFF and allow the oven to cool.
2. Remove the oven-interior racks and rack slide frames. (The rack slide frames are readily removable by merely
raising to disengage them from their sockets.) Wash the racks and rack slides in a sink with mild detergent and warm
water. Dry them thoroughly with a clean cloth.
3. Inspect for foreign matter has accumulated on the wire grate in front of the fan blower wheel on the wheel itself
(which will reduce air circulation). If necessary, remove the rear panel of the oven, which is secured by bolts near
each corner. Use a stiff brush to remove accumulations from the blower blades, then wash with soap and water.
4. Wash the interior surfaces with mild detergent and warm water. Rinse with clean water, and dry thoroughly with a
clean cloth. For stubborn accumulations, a commercial oven cleaner may be used.
NEVER use pressured water to clean the oven.
5. Clean the control panel with warm water and mild soap. Never use cleaning solvents with a hydrocarbon
base.
6. Wipe the other exterior surfaces with a clean damp cloth. If the exterior surfaces require more thorough cleaning,
see “Cleaning Stainless Steel Surfaces” on the next page.
7. Return the rack slides and racks to their appropriate locations inside the oven.
8. LEAVE THE DOOR OPEN AT NIGHT AFTER CLEANING. This allows the oven to dry thoroughly after cleaning
and also prolongs the life of the door gasket.
MONTHLY CLEANING
Clean around rear of motor (where the vent screen is located), louvered panels, and primary air holes in the rear of
the oven where grease or lint may have accumulated.
SIERRA SRCO Convection Oven