Manualshelf

User Manual

ManualsBrandsSierra ManualsCommercial Convection OvensSRCO-1 39" Commercial Convection Natural Gas Oven with 3 Inshot Burners, 54,000 BTU's, Manual Timer Control, Electronic Ignition, 5 Wire Racks, and Dependent Door, in Stainless Steel
21222324252627282930
Table Of Contents
25
CONTROL PANEL ACCESS
To access the control panel components, remove the screw at the top of the control panel and pull
the top of the control panel out and down (see drawing below). A wiring diagram for the oven is
located on the side of the control panel assembly.
Accessing Control Panel Components
CLEANING OF AIR INTAKE GRATING AND BLOWER FAN WHEEL
To clean the air intake grating or blower wheel, do the following:
1.Remove racks and rack guides.
2.Clean intake wire grating with wet rag. If necessary to remove, remove (4) small bolts holding
grating in place. After cleaning, reinstall wire grating.
3.If fan blower fan wheel is to be cleaned: Loosen (4) bolts holding entire rear panel over blower
fan opening. Remove panel.
Clean blower wheel with wet rag. (Do not remove blower wheel from motor shaft.)
4.Replace rear panel, insert bolts and tighten. Make sure fan wheel is free of any obstructions.
SIERRA SRCO Convection Oven