User Manual

32
Remove side panel of oven next to control
panel by removing screws on bottom and rear
of oven to expose the gas system and electrical
system.
This below, is what you will see.
The burners need to be removed. The burner
manifold needs to be disconnected. On front of
oven, use wrenches to loosen gas line
connection to burner manifold.
Loosen nuts holding manifold pipe to bracket and remove
screws in front of manifold bracket holding it to oven frame.
Cut cable ties holding electrical wires to manifold assembly
(remember where they are so you can replace them with
new cable ties during reinstallation.)
The burner orifices and the regulator need to
be changed. The gas type information needs
to be changed as well.
SIERRA SRCO Convection Oven