Indoor Fireplace User Manual

G8860 _4 Installation Manual NZ

25.0 Fitting the Fascia Panels:

To avoid scratches or knocks to the fascia panels of this heater they must be fitted at the

complete conclusion of the installation process. It may be necessary to use the outer fascia

to initially locate the heater but then remove it again

so that there is no chance of damage.

Note: Never Ever Rub the Fascia Panels.

Step 1: Replace the glass

Note: If the glass gasket requires

a replacement, call your nearest

Escea agent who will ensure the part is

replaced with the correct type. In the event

that the glass is broken by impact, purchase

the replacement from an authorised

Escea agent only.

Step 2: Hang the outer fascia (larger one)

from the lip that extends at the top

of the heater at 45 degrees.

If hanging a 4 sided fascia please

Refer to sections 25.1 and 25.2

on the next page.

Step 3: Fit the two screws at the base of

each side of this fascia. The heater

may have to be adjusted in or out

of the cavity to ensure the fascia fits

correctly.

Step 4: Hang the top edge of the inner fascia

(smaller one) from the lip that extends

at 45 degrees from the top of the

firebox. This fascia is held in at its base

by magnets (IB850 & IB600).

Alternatively, this fascia is screwed to the

fire chassis (IB1100).

Step 5: Place the bottom fascia trim into

position. This panel is held on

with magnets. If this panel does not fit,

adjust the outer fascia side to side or

the heater in/out until the trim fits well.