Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsToiletsSignature Hardware 1.6 GPF Golden Oak High Tank Pull Chain Toilet with Elongated Bowl
1234
2High Tank Pull Chain Water Closet Installation
5. When the toilet is properly aligned, nish tightening the washers and nuts onto the anchor bolts with an adjustable
wrench. Do this gradually, alternating from one bolt to the other until both are tight. Be sure not to over tighten, as
this could cause cracks and
damage the base of the toilet.
6. Place the bolt caps over the anchor bolts on the base of the toilet. If the anchor bolts extend too far over the top of
the washers and nuts, use a hacksaw to trim to the correct length.
7. Proceed to the Trim Kit and Tank Installation section.
REAR OUTLET BOWL INSTALLATION
1. Before installation, place the toilet in the location where it will be installed.
2. Measure the distance from the back of the waste outlet on the toilet to the wall hub tting to determine the length of
the p-trap connector. The connector should extend approximately 1-1/2" into the hub tting.
3. Trim the p-trap adapter with a hacksaw to the appropriate length as necessary.
4. Mark the location of the pre-drilled mounting holes using the holes in the base of the toilet as a template.
5. Remove the toilet from the work area and drill mounting holes in the locations designated in the previous step.
6. Apply PVC or ABS glue around the p-trap connector and place inside the hub tting.
7. Slide the toilet into place and press the waste outlet into the p-trap connector.
8. Once the toilet is securely in place, insert anchor bolts and washers through the mounting holes in the base of the
toilet and tighten into the pre-drilled holes created in step 6.
9. Place caps over the anchor bolts on the base of the toilet.
10. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ush the toilet several
times to check for any leaks around the back or base.
11. Attach the toilet seat.
12. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will nish the joint
between your oor and toilet bowl and divert water away from the base of the toilet.